Teleco Magic Sat 2002A, Руководство по установке

Страница: 12 / 44

V006
Pag. 12
This technical note is to call the attention of the installation personnel to certain details of
Magic Sat 2002A installation. During installation, you must take the following precautions:
The power supply cable must come directly from the battery and be of a minimum cross-
section of 5 sq.mm. Only the Magic Sat 2002A must be connected to this cable; all the
other devices must be connected to another
The cable connecting the motor unit to the Magic Sat 2002A Control Unit must NEVER be
cut for any reason whatsoever; should the cable turn out to be too long, wind the extra part
into a coil in a free area of the vehicle. Leave a little cable in the motor unit area; should
any technical operation be required, it will make it easier to remove the motor unit.
Also, before checking its operation, we suggest you make sure that:
the outside converter (a.k.a. LNB) has been installed properly and locked into its plastic
lock nut. Remember that the outside converter has its own assembly position which must
be complied with. Otherwise you will not receive any signal. The pre-set mounting position
for the converter is along the centre line of the disk (see figure A). With this configuration,
the MagicSat Digital system works correctly in most European countries. However, if you
are in areas very far from the satellite orbital position, it might be necessary to adjust the
converter angle. In particular, if you wish to receive transmissions from the satellites Astra
19E, Astra 28E or HotBird 13E, while you find yourself in Portugal or Morocco, your
converter angle should be adjusted as shown in figure B2, while if you are in Turkey, to
receive the same satellites you should set your converter to the position B1. A chart is
attached which may help you set the ideal angle.