9
3.1 Limit switches configuration
Open the door (in
hold-to-run
mode) in order
to set up the upper limit switch.
Close the door (in
hold-to-run
mode) in order
to set up the down limit switch.
hold-to-run
DEACTIVATION
P2
( 5 s)
keep it
pressed
Press P2 button
five times
and keep it
pressed for at least
5 seconds
.
L7
starts
flashing
.
Press P2 button
twelve times
and keep it
pressed for
5 seconds
. The buzzer emits 1
beep and L7 flash fast.
L7 flashes
slow
...
( 5 s)
keep it
pressed
HOLD TO
RUN
L7 FLASH F
AST
( 5 s)
keep it
pressed
L7 flashes
slow
...
( 5 s)
keep it
pressed
Press P2 button
five times
and keep it
pressed for at least
5 seconds
.
L7
starts
flashing slow
.
Press P2 button
thirteen times
and keep
it pressed for
5 seconds
. The buzzer emit
2 beeps.
hold-to-run
5x
12x
5x
13x
WITHIN 30 SEC. FROM POWER-ON
P2
P2
P2
Procedure only with hold to run commands.
Warning:
The safety devices are excluded!
ON
1 2 3
ON
1 2 3
ON
3.2 Deactivation of wireless safety system
This function is possible ONLY within 30 seconds from the power on of the control unit.
By default DIP1 is ON (system activated).
• Switch the unit on and move DIP1 to OFF within 30 seconds.
ON
to
OFF
The control unit will emit
6
beeps
if the system has been correctly deactivated.
It is possible activate the safety system again, moving DIP1 from OFF to ON within 30 seconds from
power-on. After keeping pressed P2 button for 5 seconds, the control unit will emit
7
beeps
.
• Press P2 button for 5 seconds and hold it down
