14
3x
Remote deletion of a radio code
Note: P3
button is located inside the transmitter. The added radio code will have the same functions of
the code used for the memorization. This procedure is compatible with any type of transmitter.
Press the button
P3
of the
memorized
transmitter. The buzzer emits a
continuous sound. Press the button relative to a
memorized
code. The sound
stops for 1 second then it starts again. Press the button relative to the
new
code. The memorization is indicated by an intermittent sound of the buzzer.
...
P3
< 5 s
intermittent
sound
To delete
1 s
...
P3
New
< 5 s
continuous
sound
Memorized
< 5 s
continuous
sound
Memorized
Memorized
Note: P3
button is located inside the transmitter.
Press
3 times
the button
P3
of the
memorized
transmitter. The buzzer emits a
slow intermittent sound. Press the button relative to the code
to delete
within
5 seconds. The buzzer will stop sounding.
2.4
2.5
Remote memorization of further radio codes
WIND sensor
3.1
The anemometer (
ANEM4
) detects wind speed, which the control unit compares with the threshold set through
DIPs 3-4
(see table).
The control unit is only compatible with anemometers generating 4 pulses per rev.
ACTIVE ALARM when
Once ACTIVE ALARM
DEACTIVATED ALARM when
The measured speed is higher then
the set threshold (see the table).
The control unit moves the louvres to the
50%
of complete
opening and it
doesn’t execute any command
.
LA
flashes.
The sensor measures a speed lower than
the set threshold for at least 30 seconds.
DIP3 DIP4
Km/h
OFF
OFF
40
OFF
ON
50
ON
OFF
60
ON
ON
70
WIND
Alarm priority
HIGH
LA flashes
EN
Factory setting
ACTIVATED
