Setup / placing a test call
Getting started
Unplug the telephone from the wall socket and plug into Novo telephone
adaptor cable.
Connect the Novo telephone cable into the telephone socket on the wall
(where the telephone was originally plugged in).
Connect the power lead between the base unit supply socket and the mains
electricity.
Place a test call to the control centre to verify installation and programming by
pressing your fall sensor.
1.
2.
3.
5.
4. Turn on the base unit by pressing the grey on/off button for roughly 5 seconds
underneath the unit.
Placing a test call
(1).
Press the red button on the base unit or press the fall sensor.
(2).
The base unit will make a series of tones as the unit dials through to the monitoring centre. It
can take up to 40 seconds to connect.
(3).
Moments later, you’ll be connected to our emergency response team. Simply tell our team that
you are making a test call to check that your alarm is working correctly.
(4).
Your alarm is set up and ready should you need it.
