TeleAdapt RoomCast TA2400, Руководство по установке и настройке

Страница: 15 / 30

TeleAdapt Roomcast Installation Guide
Setup Wizard and Cloning
This feature is available in Roomcast software release 4.10 and above only. For earlier software revisions
con
fi guration is via the Admin Mode interface, see the following section for further details.
The Roomcast Setup Wizard is designed to minimise the time taken to install Roomcast. The Setup Wizard
runs only once, on initial startup.
You will be prompted for a system ID. If you have not been given a system ID then use the default which is
“999998”. If you have been given a system ID then you should also have a PIN code, you will need to enter
both system ID and PIN to proceed.
The Setup Wizard steps through the key con fi guration parameters for Roomcast. In a typical installation
many of these parameters will be constant across multiple units, these parameters can be pre-de fi ned in a
clone fi le called “RC_Con fi guration.json” which is placed on a USB drive that the setup wizard reads. Setup
Wizard only prompts for parameters not speci fi ed in the “RC_Con fi guration.json” fi le.
Before the Setup Wizard applies any changes it will show a summary con fi guration and ask for
con fi rmation. The settings are then applied and Roomcast will display the initial Guest UI.
Clone fi le - RC_Con fi guration.json
To simplify generation of the RC_Con fi guration.json clone fi le, use a web browser and enter the URL http://
rc.teleadapt.com/custom/con fi g. Set the default values you require using the web form, any parameters you
leave unspeci fi ed will be omitted from the generated fi le and the Setup Wizard will prompt you for missing
settings when it runs. Use of RC_Con fi guration.json is not mandatory, however it is recommended to use it
to set parameters that are constant across a large number of rooms.
If for any reason you need to manually edit the RC_Con fi guration.json fi le then you must use a plain text
editor like UltraEdit, BBEdit or Atom. Using a rich text editor or word processing software will corrupt the
fi le.
The name/value pairs used in RC_Con fi guration.json are also case sensitive and only certain well de fi ned
values are allowed. For this reason the web tool is recommended.
An example RC_Con fi guration.json fi le is shown below:
{
"time_zone":"Chicago",
"topology":"in_room_pan",
"wan_ip_assign":"dynamic",
"auto_update":"enabled",
"auto_update_time": "23:00",
"room_prefix":"RM",
"idle_timeout":"3mins",
"checkout_time":"13:00",
"method":"HDMI-CEC"
}
Contact TeleAdapt for further information.
Revision 2.1 - May 2018 15 30