Installation
Before starting installation make sure you have read and
understood the “Important Safety instructions”.
Step 1
Confirm the furniture cutout dimension to accommodate the
PowerHub Mini is within the limits shown below. Note that in
addition to the minimum depth requirement of 60mm (2.36in) there
should also be at least 50mm (1.97in) clearance below the unit to
allow cabling to exit cleanly.
Step 2
Remove the PowerHub Mini, trims and screws from the box.
Step 3
Attach the supplied power cord to the PowerHub Mini flying lead
and then thread the power cord through the cutout in the furniture.
Step 4
Lean the PowerHub Mini on the bottom of the cutout in the furniture
and push it into the cutout by rotating it slightly
Step 5
Fasten the 4 cross head screws to fix the PowerHub in the furniture.
Step 6
Align the selected trim (black or metallic) with the PowerHub Mini
ensuring that the 2 small cutouts on the trim are on the bottom.
Press firmly and evenly to clip the trim into place.
Step 7
Finally insert the plug on the end of the rear power cable into an
appropriate 120V-240V mains outlet.
Installation is now complete.
6
Fitting PowerHub Mini through the cutout
Additional Information
USB Charging
The PowerHub Mini provides 1 x USB Type-C
TM
socket that can
charge up to 5V/3A and 1 x USB Type A socket that can charge up
to 5V/2.4A. The USB sockets can be used simultaneously. Overload
protection is provided in the case that the device being charged or
the cable being used is faulty.
Removing the PowerHub Mini from Furniture
If you need to remove the equipment for any reason, first ensure the
equipment is disconnected from the mains power source.
1.
Unplug the PowerHub Mini from the mains supply.
2.
Use a medium flat blade screwdriver to release the 2 clips on
the bottom of the trim.
3.
The trim can now be gently removed by hand. Be careful not
to bend the trim excessively or it may deform or break.
4.
Unscrew the 4 cross head screws and carefully withdraw the
unit from the furniture being careful not to damage any
cables.
Rotate
Push Back
Fix Screws and
Attach Trim
Step 4
Steps 5 and 6
P
o
w
e
rH
u
b
M
in
i
In
s
ta
lla
ti
o
n
G
u
id
e
7
P
o
w
e
rH
u
b
M
in
i
In
s
ta
lla
ti
o
n
G
u
id
e
