15
Unpacking
and connecting
Unpack the contents and check that nothing is
missing. Refer to Package Contents above.
Batteries in the remote control
Remove the cover on the battery compartment
and insert 2 AAA (1.5V) batteries. Note the + and
– markings and insert the batteries as indicated by
the markings. Replace the cover.
Connect to a TV
1 Connect the one end of the network cable
to the network socket on the box (marked
RJ45). The other end of the cable can be con-
nected either directly to the data socket on
the wall or, if you have a Tele2 Gateway, to
any of your gateway’s yellow sockets.
2 Connect the box to your TV, either with the
HDMI cable for optimal picture quality or
with the SCART cable if your TV does not
have a HDMI input.
Connection via HDMI
: Connect the provided
HDMI cable from the socket marked HDMI
on the box to the HDMI input on the TV.
Connection via SCART
: Connect the SCART
cable to an unoccupied SCART input on the
TV (usually marked
SCART 1
,
AV1
or simi-
lar).
3 Insert the Smart card into the card reader.
Position the chip on the card downwards and
towards the box when inserting into the box.
4 Turn on the TV.
5 Connect the power cable between the power
input on the box and a wall socket.
6 Switch on the power on the box.
If the box starts in the
power saving mode
(the
LED indicator on the front shows red), you also
need to press the red key on the remote control
marked Power.
You may have to change the input source on your
TV to for example
HDMI1
,
SCART1
,
AV1
de-
pending on which input you have connected to on
your TV. Read the user manual for your TV for
further instructions.
Now you are finished with the installation!