English
TS6206 DT
7
6 Problem
solver
PROBLEM
POSSIBLE CAUSE
REMEDY
1.
The receiver does not start / no LED
lights up on the front panel
-The receiver is active, but there isn’t
antenna signal.
-The mains lead is not plugged in.
-The mains lead is plugged in but the
receiver still does not work.
-Check/connect antenna and
SCART cables. In addition, perform
a new channel scan.
-Make sure the mains lead is
properly plugged in.
- Unplug the mains lead and check it
for damage (risk of electric shock!).
2.
No Video or Audio signal
-No signal or a poor signal.
-SCART cable or antenna cable not
connected properly.
-Audio volume low or zero.
-AV channel not selected on TV.
-Current channel is obsolete or stopped
temporarily.
-Check the SCART connection, the
antenna installation and signal
quality.
-Make sure the TV and receiver
volumes are not set to zero.
-Make sure the AV channel is
selected on the TV (consult the TV
user manual).
-Change to a valid channel.
3.
The channel scan gives no results
-No antenna signal.
-Your antenna system is not fully
compliant with the digital terrestrial
signal.
-You have an active antenna.
-Check for a signal using the
receiver menu.
-Ask for an antenna technician help.
-Check the “Antenna Setting” (refer
to chapt. 3, point 4).
4.
The settings are not saved.
-Setting changes are not confirmed
before quitting.
-Before quitting a menu press the
Confirm button to save the changes.
5.
The remote control does not work.
-The receiver is in Stand-by.
-The remote control is not being directed
towards the receiver.
-The remote control batteries are flat.
-The batteries have been inserted in the
wrong direction.
-The remote control has been dropped
and its internal components have been
damaged.
-Press the STAND-BY button on the
front panel to check the receiver is
working properly.
-Make sure nothing is obstructing the
front panel.
-Change batteries.
-Check the battery polarities.
-Contact the local dealer and buy a
new remote control.
6.
You have forgotten the Password.
-The default password is 0-0-0-0
(four zeros). If you have changed
password consult this manual at
section 4.1.
7.
The event timer function doesn't work
properly.
-The specific program transmits a wrong
time information.
-The receiver time has not been set
correctly
- Set the time from the menu (see
section 0).
9.
The receiver does not interact with
the remote control buttons.
-The receiver is temporarily blocked.
-There is a problem with the remote
control.
-Unplug the mains lead of the
receiver for at least one minute and
then plug it back in.
-Go to point 5 of this chapter.
