etc. Use an extension cable and place the device outside.
The following recommendations are applicable to all wireless devices:
• Do not touch or move the antenna while the device is transmitting or receiving.
• Do not touch any equipment containing devices that radiate, where the antenna is very close to or touching any ex-
posed part of the body (particularly the face and eyes), when it is transmitting.
• Do not install the device in areas where the atmosphere is potentially explosive.
• Wireless devices can cause interference with other devices. Do not use the device in areas where medical equip-
ment is installed.
• To ensure the RED 2014/53/EU directive is complied with, the device must be at least 20 cm away from a person’s
body when operating.
3.5.3 Connecting the serial ports
The Regesta PLC includes a RJ45 and a 7 pin pluggable connector to provide serial ports. Depending on the model,
the 7 pin pluggable connector may be inoperative.
3.5.3.1 Console connector as serial port (CONF connector)
The console port can be converted into an RS-232 asynchronous DCE serial port. This port has the following charac-
teristics:
(1)
DCE port.
(2)
RS-232 norm.
(3)
Maximum speed of 38400 bps.
(4)
Only the following signals are available: RxD (pin 2), TxD (pin 3) and GND
(5).
(5)
RJ45 connector.
Fig. 16: Console connector
3.5.3.2 Asynchronous serial ports
The Asynchronous Serial Port feature is optional and requires some additional hardware components. Some models
are equipped with 2 additional serial ports. The Regesta PLC includes a 7 pin pluggable connector to provide these
serial ports. This connector may not work, depending on the model. Check the label to verify whether serial ports are
included on the device.
3 Components and Power Supply
Teldat S.A.
18
Regesta PLC
