Teldat M12AB, Инструкция по эксплуатации

Страница: 11 / 15

11
Auto-answer OGM is a conventional message to tell the caller some information of the owner.
There are two groups OGM can be recorded, one for “ANSWER A1” mode and another for
“ANSWER A2” mode.
Record OGM for “ANSWER A1” mode as follows:
In on-hook state press ON/OFF/STOP key to select “ANSWER A1”, press OGM key for about 2
seconds and release; record OGM after hearing a long beep. Be sure to speak clearly into the
microphone from 6-8 inches (15-20cm) away. You have one minute to record your message.
Recording will stop automatically after 60 seconds, or press ON/OFF/STOP key to stop
recording. Then the machine will play the OGM for your review immediately. Press
ON/OFF/STOP key will stop playback.
In on-hook state press OGM key, your recorded OGM will be played back. Press V+ and V- keys
to adjust the volume. Press ON/OFF/STOP key will stop playback.
Record OGM for “ANSWER A2” mode: In on-hook state press ON/OFF/STOP key to select
“ANSWER A2”, other steps follow above operations.
OGM3
Announce-only OGM (OGM3) is an answer-only message; user cannot change OGM3. It is
pre-stored in the DSP. When memory is full or the total numbers of saved messages exceed 59,
OGM3 will be announced to remind the caller that memory is full. After OGM3 is announced,
caller can not do record operation and only can perform the remote operation.
NOTE: OGM3: “Memory full, please call again later, thank you.”
ICM (Incoming Message) Recording
When a call is received under auto-answer being ON and “ANSWER A1” mode, the machine will
allow the caller to record an ICM.
Record ICM as follows:
The telephone answers the call and then plays OGM to the caller.
Start to record a message to the machine after a long beep sound.
The ICM recording stops if any of the following events occurs, i.e., 8 seconds of silence or
continuous same frequency signal or 5 seconds busy tone are detected or record time up to the
set length (1 or 2 minutes), or parallel phone is picked up, or ON/OFF/STOP key is pressed. If
pick-up signal of parallel phone is detected, the ongoing message record will be saved as a new
message. If ON/OFF/STOP key is pressed, the ongoing message record will not be saved.
A long beep tone will be transmitted to indicate that ICM recording is finished.
If ICM has been recorded, RECORD LED will flash to indicate the presence of new message.
NOTE: If memory full occurs during ICM recording, pre-recorded OGM3 “Memory full, please call
again later, thank you.” will be announced before the machine releases line.
Memo (family message) recording
Memo is a message left for family or others via the answering machine. The person who is