1.5 PMC-PCI Cards
The ATLAS X60 features and interfaces can be amplified by inserting PMC boards (PCI mezzanine card). In order to
correctly insert the card, please follow the steps given below.
Fig. 16:
PMC-PCI SLOT for the ATLAS 160 and ATLAS 260
Fig. 17:
PMC-PCI SLOTS for the ATLAS 360
1.5.1 Procedure to install PMC cards
(1)
Switch off the device and remove the cables (as described in the section on connection in this manual).
(2)
Remove the device from the workplace and place it in a stable, safe place where it can be easily accessed and
handled. Open up the device. To do this, you need to remove the upper cover which is secured through two
screws located on the underside of the device.
(3)
Once the screws have been removed, in order to remove the cover, slide it towards the back panel and then re-
move it by lifting it. Place it in a safe place
(4)
Find the place where the PMC board needs to be placed. This slot has a set of raised connectors with gold con-
tacts and a pair of securing screws.
(5)
Remove the blind cover from the slot. This cover is located either on the rear panel ( ATLAS 160 and ATLAS
260) or on the front panel (ATLAS 360 ). Push this out
(6)
Place PMC board securing posts over the securing screws. Secure these firmly.
(7)
Place the PMC card in the slot so that this firstly adjusts to the space on the device rear panel and subsequently
to the two PMC connectors. This operation must be carefully carried out without forcing any piece or part of the
device. Check that the board is clearly seated over the PMC connectors
(8)
Screw the PMC board to the posts. For this, use two screws with their corresponding washers. Firmly tighten
the screws without damaging the board.
(9)
Close the device with the cover. Secure the cover with the screws.
(10) Connect and switch on the device as explained in the connection section. Should you detect any problems,
switch off the device and make sure that the above steps have been carried out correctly. If the problem per-
sists, please contact your usual supplier.
(11) Connect a terminal to the console and check that the device detects the PMC board.
**************************************************
******************* Router Teldat ****************
**************************************************
BIOS CODE DUMP...................
BIOS DATA DUMP....
End of BIOS dump
Boot-stack used: 0x000007A0
Boot-stack free: 0x00001860
===========================================================
BIOS TELDAT
(c)Teldat
====================================================================
FLASH BIOS CODE VERSION: 01.04
Nov 26 2007 12:29:48
L0
Current date: Dec 05 2007, Wednesday Current time:17:42:14
1 Installing the Router
Teldat S.A.
10
ATLAS X60
Содержание ATLAS X60
Страница 4: ...Table of Contents Teldat S A ii ATLAS X60 ...