Metallic connector:
-Left:
ORANGE: 10Mbps. Flashing depends on the activity.
GREEN: 100Mbps. Flashing depends on the activity.
-Right:
YELLOW: 1000Mbps. Flashing depends on the activity.
OFF: Both off means the link has not been detected.
1.4 Programming the microswitches
The ATLAS X60 router has a block of 8 available micro-switches, which are used for maintenance and test tasks. To
access these you need to carry out the following steps:
• Switch off the device using the ON/OFF switch.
• Using a screwdriver, open the device.
• Have the device facing you (where the LEDs are located). In this position, the block of micro-switches can be seen
in the upper left hand corner on the motherboard, next to the box ventilators.
In this case, they are only used to load the default configuration. These switches should not be handled by the user
other than to establish the default configurations.
Note
For the device to operate correctly, all micro-switches must be in the OFF position.
1.4.1 Procedure to ignore the configuration
Follow the steps below if you have to discard the whole configuration of the device (for instance, if you cannot re-
member the password).
The procedure is as follows:
• Turn off the device through the ON/OFF switch.
• Open the device.
• Using a screwdriver, move micro-switch ‘5’ to the ON position.
• Close the device.
• Turn the device on with the ON/OFF switch.
When the device is switched on, a message similar to the one shown below will appear on the configuration console:
**************************************************
******************* Router Teldat ****************
**************************************************
BIOS CODE DUMP...................
BIOS DATA DUMP....
End of BIOS dump
Boot-stack used: 0x000007A0
Boot-stack free: 0x00001860
==========================================================
BIOS TELDAT
(c)Teldat
1 Installing the Router
Teldat S.A.
8
ATLAS X60
Содержание ATLAS X60
Страница 4: ...Table of Contents Teldat S A ii ATLAS X60 ...