Each slot has a set of elevated connectors with gold contacts and a pair of screws.
(5)
Remove the blind cover from the selected slot. This cover is located on the rear panel and is secured by three
screws. You will need a flat screwdriver to do this.
(6)
Screw the circuit board mold that came with the board and that allows the board to sit better in the rear panel of
the device. Use the screws mentioned above to fasten it.
(7)
Place PMC board posts over the screws. Secure these firmly.
Teldat S.A.
4 Appendices
ATLAS 300 Installation Manual
23
