Current serial number: 591/05411
BIOS MAC Add: 00-a0-26-10-95-23
>>
...
......
TRYING APP CODE DUMP
(CONFIGURED) ATLAS3G.BIN ver.: 0.10.7.12 0.0.0.0. .............................
APP DATA DUMP ....................................................................
Bios-stack used: 0x1588
Bios-stack free: 0x2A78
Aux-stack used: 0x13C
Aux-stack free: 0x1EC4
Running application
Parsing text mode configuration ...
Configuration parsed
Initializing
Press any key to get started
I - 6.
16 Port SWITCH Board
“SWC” SLOT for the ATLAS 360 16 port Switch board
The
ATLAS 360
features and interfaces can be amplified by inserting a 16
port Switch board in the “SWC” slot which can be found on the device rear panel.
In order to correctly insert the board, please follow the steps given below.
1.
Switch off the device and remove the data cables as described in the section
on connection in this manual
2.
Using a screwdriver, remove the cover over the “SWC” spot. This cover is
located on the rear panel.
3.
Should there be a “dummy” board installed, remove it.
4.
Insert the 16 port switch board. This operation must be carefully carried out
without forcing any piece or part of the device.
5.
Screw down the board. Firmly tighten the screws without damaging the
board.
6.
Connect and switch on the device as explained in the connection section.
Should you detect any problems, switch off the device and make sure that
the above steps have been carried out correctly. If the problem persists,
please contact your usual supplier.
7.
Connect a terminal to the console and check that the device detects the
Switch board.
ATLAS X60
Installation
I-14
Doc.
Dm695-I
Rev.
1.0
