ATLAS 150
Installation
I-10
Doc.
Dm697-I
Rev.
1.0
A
OFF:
Slot is empty. There is no card.
RED:
ERROR: a card has been detected in the slot but operating incorrectly.
YELLOW: Initialization/configuration in process.
GREEN:
Card initialized and operating correctly.
S
L
O
T
1 - 2
B
OFF:
The card is not executing any operations.
RED:
Depending on the type of card.
YELLOW: Depending on the type of card.
GREEN:
Depending on the type of card.
SLOT
3
A - B
The device has a MINI-PCI slot where you can install a Wireless LAN daughter card.
Please see the manual on Wireless LAN interfaces to check the meaning of the LEDs’ operations.
I - 4.
Programming the Microswitches
The
ATLAS 150
router has a block of 8 microswitches available,
located on
the underside of the device,
which are used for maintenance and test tasks. In
this case, they are only used to load the default configuration.
These switches should not be handled by the user except to establish the default
configurations.
So the device operates correctly, all the microswitches must be in the
OFF position.
I - 4.1.1.
Procedure to ignore the configuration
This procedure is applied if you have to discard the whole configuration of the
device, for example, if you cannot remember the password.
The procedure is as follows:
•
Turn off the device through the ON/OFF switch.
•
Using a screwdriver move microswitch ‘5’ to the ON position.
•
Turn the device on with the ON/OFF switch.
When the device is switched on, a message similar to the one shown below will
appear on the configuration console:
