Telcoma Automations VEDO180 PRO, Инструкции по эксплуатации и программированию

Страница: 25 / 36

GB GB
24 25
FINAL ADVICE
Do not perform any wiring or modifications to the connections prior to
having isolated the power supply.
The non-observance of the said instructions could prejudice the correct
function of the equipment.
TELCOMA decline any responsibility for possible malfunction and/or da-
mage due to their non-observance.
TELCOMA srl reserve the right to make modifications at any time they
deem necessary in order to improve the aesthetical and/or functional
aspect of the product.
Conegliano, 23/11/2012
GUARANTEE
The present guarantee covers possible faults and/or irregularities due to
manufacturing defects and/or faults.
The guarantee will automatically expire in the event of tampering or
misuse of the product.
During the guarantee period TELCOMA srl pledge to repair and/or replace
defective and non-tampered parts. The call charges, as well as the
collection, packaging and transportation costs of the product for repair or
replacement are at the clients full and exclusive expense.
DISPOSAL
This product is made up of various parts that could contain
polluting substances.
Avoid release to the environment!
Enquire about the local recycling or disposal systems in
compliance with present laws and regulations.
EC DECLARATION
The undersigned, Ennio Ambroso, legal representative of TELCOMA
S.r.l., declares that the product
VEDO180PRO used as a gate automation
photocell:
Is in accordance with the essential requirement of Directive 89/336 (EMC:
EN 61000-6-3 + EN 61000-6-1) and Directive 73/23 (LVD: EN 60335-1)
and subsequent modifications, if implemented for the said use.
The above mentioned product is an integral part of the typical installation
configurations as illustrated in our general catalogue.
OPTIC ALIGNMENT
The VEDO180PRO photocells can be horizontally adjusted to over 180°.
Slacken screw 3 in figures 1 and 2, rotate the internal parts of the
photocells until they are out of alignment, then carefully tighten the screws.
The red led of the receiver (detail 9 fig. 1) is on when the photocells are
aligned.
Slight vertical alignment differences are compensated by a self-centring
lens system.