Telair Iceberg 3500, Инструкция по установке и эксплуатации

Страница: 7 / 24

- 7 -
GB
In order to install the air conditioner, you must first
make sure the roof of the vehicle is able to hold its
weight. If not, reinforce it. Choose a central, level
and flat area on the roof. Make sure that no obstacle
inside the vehicle can hinder fastening of the diffuser
[Fig.1 ref. 4] and the exit of the cooled air from the
adjustable outlets [Fig. 1 ref. 5] .
To install the air conditioners, you can choose ei-
ther of two solutions:
Remuve existing rooflight and use aperture
Cut new aperture.
4.2.1 Using rooflight aperture
You can do so on condition that the aperture of the
rooflight measure of 400 x 400 mm. For the
dimensions of the air conditioners and of the holes
required to install them, refer to figure 2.
2
Remove existing rooflight and sealants making sure
roof surface is clean and even
[Fig. 3 ref. 1] Seal
any screw holes and or cable entrance holes so
that no water can penetrate the roof space, using a
suitable sealent
[Fig. 3 ref. 2] .
All the waste material - glue,
silicone, lining - must not be disposed of in the
open, but in special containers and delivered
to a Waste Collection and Disposal Centre.
3
1
2
4.2.2 Opening a new hole
Choose a flat level position on the vehicle roof
beteween the support structure. Mark the aperture
400 x 400 mm square
[Fig. 4 ref. 1] .
Carefully cut out the opening on the roof, making
sure that no damage will be caused e.g. cables,
hoses, furniture, fittings.
[Fig. 4 ref. 2] .
Wear safety goggles and
gloves before using any power tools or hand-
saws.
Make a reinforcing frame along the perimeter of
the opening. Make a hole on one side in order to
lead the power supply cable through
[Fig. 5] .
1010
615 395
18
0
400
400 400
620
1010
615 395
240
400