Telair Iceberg 12000, Инструкция по установке и эксплуатации

Страница: 6 / 32

GB
- 6 -
3
SHIPPING, HANDLING, STORAGE
3.1 Storage
The air conditioner is protected during shipping by
suitable packaging. The air conditioner must be
stored horizontally, in a covered, dry and ventilated
area.
The packaging is designed so as to allow stacking
of a maximum of 5 (five) air conditioners.
Do not turn the unit upside
down. The right position is the one shown by
the symbol printed on the package ( ) .
Stacking more than 5 air con-
ditioners will not only compromise the integ-
rity of the equipment, but will also be a risk to
personel.
3.2 Weight
Weight without packing.
ICEBERG 7000 Kg 37
ICEBERG 12000 Kg 39
3.3 Handling
The air conditioners, complete with their packag-
ing, can be moved using common lifting and trans-
port vehicles.
The boxes are provided with spacers in order to
allow for the introduction of transpallet forks.
During lifting and transport,
comply with accident prevention and safety
regulations. Use lifting and transport equipment
with a capacity greater than the load to be lifted.
4
INSTALLATION
4.1 Preliminary information
Before installing the air condi-
tioner, it is essential to read these instructions,
in order to avoid errors during installation
Improper installation of the air
conditioners can cause irreparable damage to
the equipment and compromise the safety of
the installation engineer.
Should the air conditioners be installed in a man-
ner which does not comply with the instructions in
this manual, the Manufacturer shall be held blames
for malfunctions or for the safety of the air condi-
tioner, under D.M. 89/392/EEC. Furthermore, he
shall be held blameless for any damage or injury to
persons
or things.
Installation must be performed
by qualified and properly trained personnel
only.
4.2 Installation
Before starting to install, you
must disconnect all the power supply of the
vehicle
Positive battery pole
Generator set (if present)
Outside power source.
Lack of compliance with these
instructions implies a risk of electrical shock.
Before going onto the roof of
the vehicle, you must make sure that it has been
designed to be walked on. Check with the per-
son who equipped the vehicle. Otherwise, you
will have to prepare suitable scaffolding.