Telair Iceberg 12000, Инструкция по установке и эксплуатации

Страница: 10 / 32

GB
- 10 -
4.4 Installing the diffuser
After securing the air conditioner to the roof of the
vehicle, connect the power supply cable to the con-
nection terminal board [Fig. 10 ref. 3], located on
the diffuser, complying with the positions shown on
the adhesive label:
blue wire: neutral
brown wire: positive
yellow-green wire: earthing ( )
Fit the multi-pole cable connector [Fig. 10 ref. 2]
coming from the diffuser into the connector of the
conditioner [Fig. 10 ref. 1]. Fit both connectors,
10
pressing until they are firmly fastened.
Before fastening the diffuser to
the ceiling of the vehicle, make sure that no
cable is in contact with the resistances of the
fan speed selector switch [Fig. 11 ref. 1], because
- when the air conditioner is running - these be-
come very hot and can cause a serious hazard
for the insulation of the power cables.
Make sure that both resistances of the fan speed
selector switch are not in contact with each
other [Fig, 12 ref. 1] but are clearly separated
[Fig. 12 ref. 2].
Make sure that the power supply cable is not
too long, to avoid jamming the air intake holes
[Fig. 1 ref. 6].
12
11
1
2
13
1
Extend the air ducts [fig. 13 ref. 1] by 1 cm beyond
the roof thickness and fit them between the diffuser
[fig. 13 ref. 2] and the air conditioner openings [fig.
13 ref. 3], Fasten the diffuser to the frame, using
the relevant four screws [fig. 13 ref. 4]. Fit the air
ducts[fig. 13 ref. 1] between the diffuser [fig. 13
ref. 2] and the linings [fig. 13 ref. 6].