Tekvox TEK-MUHD44TP 79055, Руководство пользователя

Страница: 19 / 27

TEK-MUHD44TP 4x4 HDBaseT Matrix
TEKVOX, INC. 15 www.tekvox.com
830.460.9099
Command Function Feedback Example
AV: 04->04
IR: 01->01
… …
IR: 04->04
Save[Y].
Save the present operation to the preset command
[Y], ranges from 0 to 9.
Save To FY (Y=0-9)
Recall[Y]. Recall the preset command [Y].
Recall From FY (Y=0-
9)
Clear[Y]. Clear the preset command [Y]. Clear FY (Y=0-9)
PWON. Work in normal mode. PWON
PWOFF.
Enter into standby mode and cut off the power supply
to HDBaseT receivers.
PWOFF
STANDBY.
Enter into standby mode. (Do not cut off the power
supply to HDBaseT receivers, press other buttons or
send other commands to start.)
STANDBY
/%[Y]/[X]:[Z].
HDCP management command.
[Y] is for input (value: I) or output (value: O); [X] is the
number of the port, if the value of X is ALL, it means
all ports; [Z] is for HDCP compliant status, the value
may be 1 (HDCP compliant) or 0 (not HDCP
compliant).
/%[Y]/[X]:[Z].
DigitAudioON[x].
Enable HDMI audio output of port x.

X=1, 2, 3, 4, enable this port.

X=5, enable all the 4 ports.
DigitAudio ON with [x]
DigitAudioOFF[x].
Disable HDMI audio output of port x.

X=1, 2, 3, 4, disable this port.

X=5, disable all the 4 ports.
DigitAudio OFF with
[x]
/+[Y]/[X]:******.
Set communication between PC and HDBaseT
receiver.

Y is for RS232 port (connect with RS232 port of HDBaseT
receiver)
Y= 1~5 or A~H, The value of Y is defined into the following
meanings (in a given baud rate depended by the value of
X):
a. Y = 1~4, send this command to the corresponding
HDBaseT receiver to control far-end device.
b. Y = 5, send this command to all HDBaseT receivers to
control all far-end devices.
c. Y = A, B, C, or D
d. Y = E, F, G, or H
For items c or d, send this command, it will be
saved to the matrix switcher but taken without
action to corresponding HDBaseT receiver. And
its command function will be effective almost at
the same time when you send the command
PWON (for item c) or PWOFF (for item d).
Note:
A & E are for port 1. B & F are for port 2.
C & G are for port 3. D & H are for port 4.

X is for baud rate, its value ranges from 1 to 7 (1--2400, 2--
******