Tektronix TMSMPH4 mPGA479, Инструкция по эксплуатации

Страница: 16 / 48

Getting Started
2
TMSSY2 mPGA479 Socket Hardware Support
Logic Analyzer Configuration
To use the probe adapter to acquire state signals, you need a Tektronix Logic
Analyzer equipped with four, merged 235 MHz, TLA7Ax4 logic analyzer
modules.
The modules must be configured and merged as shown in Figure 1. The memory
depth is automatically based on the shallowest memory depth of the modules.
The term Master module refers to the second module of a 4-wide module
configuration. (See Figure 1). The term Slave module refers to the modules to
the left or right of the Master module.
M
A
S
T
E
R
S
L
A
V
E
2
S
L
A
V
E
1
S
L
A
V
E
3
Figure 1: Master and Slave module configuration
All signals are acquired through probes connected to the logic analyzer. Use the
logic analyzer modules and the P6960 probes to connect to the probe adapter.
The probes should already be labeled; if you need to apply labels, refer to the
instructions that came with your probe documentation.
CAUTION.
To prevent damage to the P6960 connectors on the preprocessor unit,
Tektronix recommends that you use the strain relief method that is described in
the
P69XX Series Instruction Manual,
Tektronix part number 071-1528-XX, after
connecting the P6960 probes.
You can access the P69XX Series Instruction Manual from the Tektronix.com
Web site.