Tektronix TLA7000 Series, Руководство по установке

Страница: 27 / 121

Basic Installation
Figure 3: Network switch
TLA7PC1 Benchtop PC Controller. This optional PC-based controller is preloaded
with the TLA Application software and connects to the benchtop mainframe
through the GbE switch. The controller is housed in a 19 in-wide chassis for
mounting to your instrument rack, or you can mount it to the benchtop mainframe
using the benchtop bracket kit. (See page 2,
Installing the Bracket Kit .) The
controller includes two removable hard disk trays located behind a lockable front
door. One tray holds the main hard disk drive. The other tray can be
fi lled with a
SATA hard disk drive provided by the user. (See Figure 4.)
Figure 4: TLA7PC1 Benchtop PC Controller
Preset IP Addresses You may need to change the IP address of the benchtop mainframe(s), depending
on the number of mainframes you have connected in your test system, and the
requirements of the network that it will be connected to.
A preset list of recommended IP addresses is programmed into the benchtop
mainframe. (See Table 3.) You can also set a speci
fi c address. (See page 32,
Changing the TLA7016 Factory Network Settings .)
To cycle through the list of preset IP addresses, do the following:
1. Press and hold the reset button on the TLA7016 Interface Module. (See
Figure 5.)
The front-panel display cycles every 2-3 seconds to the next preset address.
(See Table 3.)
Figure 5: Setting the IP address
2. Release the reset button when the desired address is displayed.
TLA7000 Series Logic Analyzers Installation Manual 9