Tektronix TG700, Руководство пользователя

Страница: 98 / 343

Operating Basics
Connecting to a Network
The TG700 has a 10 BASE-T port on the rear panel that allows you to use a
PC to remotely control the instrument and to upload and download
fi les such
as signal or logo
fi les.
This section provides instructions for connecting the TG700 to a single PC or to a
network, and for setting the network parameters on 10 BASE-T port.
Refer to the TG700 PC Tools Technical Reference for detailed information about
how to upload and download fi les using the 10 BASE-T port.
Connecting the TG700 to
your PC(s)
The TG700 uses the rear-panel 10 BASE-T port to communicate with a PC or
network. Use one of the following two methods to connect the TG700 to your
PC(s). (See Figure 2-2 on page 2-3.)
If you are connecting the TG700 directly to a single PC, use a crossover
Ethernet cable to connect between the 10 BASE-T port on the TG700 and
the Ethernet port on the PC.
If you need to construct your own crossover cable, use the following fi gure to
change the pin connections on a straight cable to produce a crossover cable.
(See Figure 2-27.)
If you are connecting the TG700 to your local Ethernet network, use a straight
Ethernet cable to connect between the 10 BASE-T port on the TG700 and
the Ethernet hub port of your local network. By connecting to an Ethernet
network, you can access the TG700 using any PC on the network.
Figure 2-27: Pin connections for a 10BASE-T crossover Ethernet cable
Setting Ethernet Network
Parameters
Use the NETWORK SETUP submenu to set the network parameters for the
TG700.
Accessing the NETWORK SETUP Submenu.
Perform the following procedure to access the NETWORK SETUP submenu.
1. Press the front-panel MODULE button repeatedly to display the mainframe
main menu.
2. Use the up ( ▲ ) or down ( ▼ ) arrow button to select UTILITY , and then press
the ENTER button. This accesses the UTILITY submenu.
2–30 TG700 TV Signal Generator Platform User Manual