Tektronix TG700, Руководство пользователя

Страница: 71 / 343

Operating Basics
Rear-Panel Connectors
The following fi gure shows the locations of the TG700 mainframe and module
connectors on the rear panel. A brief discussion of each connector follows the
illustration.
CAUTION. If power is applied to the mainframe, be sure to terminate any unused
outputs on any of the modules using 75 Ω terminators.
Figure 2-2: TG700 rear panel
Power Connector The TG700 is designed to operate from a single-phase power source with the
neutral conductor at or near earth ground. Only the line conductor is fused for
over-current protection. A protective ground connection through the grounding
conductor in the power cord is essential for safe operation.
WARNING.
Injury or death can occur as the result of electrical shock. To avoid
electrical shock, do not connect power to the TG700 when the top cover is off.
Dangerous potentials are present on the Power circuit board.
The TG700 operates from an AC line frequency of 48 to 63 Hz, over the range
of 100 - 240 VAC (
±10%)
, without the need for con fi guration. (See Table 1-4
on page 1-8.)
10 BASE-T Port Use this port to connect to your local Ethernet network. You can control the
TG700 mainframe and all installed modules remotely through the port. Also, you
can upload and download various
fi les such as signal fi les, logo fi les, and preset
fi les through the port.
TG700 TV Signal Generator Platform User Manual 2–3