Safety
Safety
viii
Observe all of these precautions to ensure your personal safety and to pre-
vent damage to either the oscilloscope or equipment connected to it.
Power Source
The oscilloscope is intended to operate from a power source that will not
apply more than 250 V
RMS
between the supply conductors or between either
supply conductor and ground. A protective ground connection, through the
grounding conductor in the power cord, is essential for safe system operation.
Grounding the Digitizing Oscilloscope
The oscilloscope is grounded through the power cord. To avoid electric shock,
plug the power cord into a properly wired receptacle where earth ground has
been verified by a qualified service person. Do this before making connec-
tions to the input or output terminals of the oscilloscope.
Without the protective ground connection, all parts of the oscilloscope are
potential shock hazards. This includes knobs and controls that may appear to
be insulators.
Use the Proper Power Cord
Use only the power cord and connector specified for your product. Use only a
power cord that is in good condition.
Use the Proper Fuse
To avoid fire hazard, use only the fuse specified in the parts list for your
product, matched by type, voltage rating, and current rating.
Do Not Remove Covers or Panels
To avoid personal injury, do not operate the oscilloscope without the panels or
covers.
Electric Overload
Never apply a voltage to a connector on the oscilloscope that is outside the
voltage range specified for that connector.
Do Not Operate in Explosive Atmospheres
The oscilloscope provides no explosion protection from static discharges or
arcing components. Do not operate the oscilloscope in an atmosphere of
explosive gases.
Specific Precautions
Содержание TDS 620
