4
4681FXI Ð Upgrading a Phaser 220e to a Phaser 220i
8.
If installed, remove the RAM SIMM installed in J6 of the 220e image
processor board.
9.
If you removed a RAM SIMM from the 220e image processor board in
Step 8, insert it in the 220i image processor board's connector J6 (or in
J7 if J6 is already Þlled) (
a
), and tilt the module upright until it locks in
place (
b
).
When properly inserted, a tab on each end of the connector slips into a
hole on each end of the RAM SIMM. Also, a pawl on each end of the
connector latches around each end of the RAM SIMM to lock it in
place.
10.
Repeat Step 9 to install an additional memory module in J7 if a second
SIMM is available.
11.
Install the 220i image processor board in the card cage. Close and
secure the card cage top.
12.
Install the Phaser 220i's I/O board. Be sure to plug in its two I/O
cables to the image processor board.
13.
After you install this upgrade kit, be sure to afÞx the F-kit upgrade
serial number sticker to the printer. Attach the sticker to the right of
the existing printer serial number.
14.
Close and secure the card cage top. Reinstall the rear cabinet panels.
15.
Reconnect the host interface cables. Turn on the printer and make a
print.
8699-65
RAM
SIMMs
J6
J7
a
b
a
b
