Tektronix P6910, Инструкция по эксплуатации

Страница: 10 / 48

Compliance information
Compliance information
This section lists the safety and environmental standards with which the
instrument complies.
Safety compliance
Equipment type
Test and measuring equipment.
Safety class Class 1 – grounded product.
Pollution degree
description
A measure of the contaminants that could occur in the environment around
and within a product. Typically the internal environment inside a product is
considered to be the same as the external. Products should be used only in the
environment for which they are rated.
Pollution Degree 1. No pollution or only dry, nonconductive pollution occurs.
Products in this category are generally encapsulated, hermetically sealed, or
located in clean rooms.
Pollution Degree 2. Normally only dry, nonconductive pollution occurs.
Occasionally a temporary conductivity that is caused by condensation must
be expected. This location is a typical of
fi ce/home environment. Temporary
condensation occurs only when the product is out of service.
Pollution Degree 3. Conductive pollution, or dry, nonconductive pollution
that becomes conductive due to condensation. These are sheltered locations
where neither temperature nor humidity is controlled. The area is protected
from direct sunshine, rain, or direct wind.
Pollution Degree 4. Pollution that generates persistent conductivity through
conductive dust, rain, or snow. Typical outdoor locations.
Pollution degree Pollution Degree 2 (as de fi ned in IEC 61010-1). Note: Rated for indoor use only.
vi P6910 General Purpose Probe Instruction Manual