Tektronix P6450, Инструкция по эксплуатации

Страница: 18 / 51

Operating Basics
-3.5 V to +6.5 V input operating range
500 mV minimum single-ended signal amplitude
Minimal loading of 0.7 pF at 20 k Ω to ground
Operation in normal or inverted polarity is acceptable (clock only)
Attaching Probe Labels
When you purchase the P6450 logic analyzer probe, you must apply the
color-coded labels as described in this section. The labels help you identify the
probe connections at the logic analyzer end and at the target system end.
The following table lists the probe section and label color combinations. (See
Table 1.) Refer to the table and to the following
fi gure when you attach the probe
labels. (See Figure 2 on page 4.)
Table 1: Probe section and label combinations
Probe
section
Channels
Label
color Probe
section
Channels
Label
color
A3-A2
CK0,
A3:7-0,
A2:7-0
Brown A1-A0
CK1,
A1:7-0,
A0:7-0 Orange
D3-D2 QUAL0,
D3:7-0,
D2:7-0 Blue D1-D0 CK2,
D1:7-0,
D0:7-0 Yellow
C3-C2 CK3,
C3:7-0,
C2:7-0
White
C1-C0 QUAL1,
C1:7-0,
C0:7-0 Gray
E3-E2 QUAL3,
E3:7-0,
E2:7-0 Green E1-E0 QUAL2,
E1:7-0,
E0:7-0 Violet
P6450 Labels
Use the following instructions to attach probe labels to your Tektronix P6450
Logic Analyzer Probe.
NOTE.
Always use fl at-nosed tweezers to remove the labels from the sheet of
labels. Never peel labels with your fi ngers. The labels are made of soft vinyl and
can stretch and distort easily. To avoid stretching the label, always grasp it from
the top right corner while removing it from the sheet of labels.
The adhesive on the vinyl labels is extremely strong. Carefully align each label to
the intended outline on the module end and probe head before attaching it to the
probe. Once labels are placed on the probe, they become very dif
fi cult to remove.
2 P6450 High-Density Logic Analyzer Probe Instruction Manual