Maintenance
Table 2: Internal inspection checklist
Item
Inspect for
Repair action
Circuit boards
Loose, broken, or corroded solder
connections. Burned circuit boards. Burned,
broken, or cracked circuit-run plating.
Remove and replace damaged circuit board.
Resistors
Burned, cracked, broken, blistered condition.
Remove and replace damaged circuit board.
Solder connections
Cold solder or rosin joints.
Resolder joint and clean with isopropyl
alcohol.
Capacitors
Damaged or leaking cases. Corroded solder
on leads or terminals.
Remove and replace damaged circuit board.
Wiring and cables
Loose plugs or connectors. Burned, broken,
or frayed wiring.
Firmly seat connectors. Repair or replace
modules with defective wires or cables.
Chassis
Dents, deformations, and damaged
hardware.
Straighten, repair, or replace defective
hardware.
Interior Cleaning
1.
Blow off dust with dry, low-pressure, deionized air (approximately 9 psi).
2.
Remove any remaining dust with a lint-free cloth dampened in isopropyl
alcohol (75% solution) and rinsed with warm deionized water. (A
cotton-tipped applicator is useful for cleaning in narrow spaces and on circuit
boards.)
NOTE.
If, after performing steps 1 and 2, a module is clean upon inspection,
skip the following steps.
If there is still dust or dirt on the module, the oscilloscope may be spray washed
using a solution of 75% isopropyl alcohol by following these steps:
a.
Spray wash dirty parts with isopropyl alcohol and wait 60 seconds for the
majority of the alcohol to evaporate.
b.
Use hot (120 °F to 140 °F) deionized water to thoroughly rinse them.
c.
Dry all parts with low-pressure, deionized air.
d.
Dry all components and assemblies in an oven or drying compartment
using low-temperature (125 °F to 150 °F) circulating air.
Lubrication
There is no periodic lubrication required for this oscilloscope.
12
MDO3000 Series Mixed Domain Oscilloscopes Service Manual
Содержание MDO3000 Series
