KPCI-488LPA GPIB Controller Interface Card Quick Start Guide
4
KPCI-488LPA-903-01 Rev. B /
January 2020
Hardware installation
The KPCI-488LPA contains sensitive components that can easily be damaged by static
electricity. Handle the module on a grounded anti-static mat. The operator should be wearing
an anti-static wristband, grounded at the same point as the anti-static mat.
You must install the drivers before installing the hardware. See
(on page 2).
To install the KPCI-488LPA:
1.
Turn off your computer and all accessories connected to your computer.
2.
Disconnect the power cord from the power source.
3.
Open your computer case.
4.
Select a vacant PCI slot.
5.
Discharge any static buildup on your body by touching the metal case of the computer before touching the
KPCI-488LPA card.
6.
Position the board into the PCI slot you selected.
7.
Secure the card in place at the rear panel of the system.
8.
Replace your computer's case.
In most Microsoft Windows
®
10 configurations, the KPCI-488LPA hardware is automatically configured by the
operating system when you power on your computer. However, previous versions of Windows may display the
Found New Hardware Wizard.
You can initiate the wizard manually with older versions of Windows.
To manually initiate the Found New Hardware Wizard:
1.
From the Control Panel on your computer, select
Add Hardware
. The Add Hardware Wizard dialog box
displays.
2.
Select
Next
. The wizard searches for any new hardware that has not yet been installed.
3.
The Found New Hardware Wizard will display. Click
Next
and follow the prompts.
If the wizard does not find any new hardware, turn your computer off and turn it on again. Once it has rebooted,
the Found New Hardware Wizard should launch.