Tektronix Keithley 2268 Series, Справочное руководство

Страница: 19 / 253

2268S-901-01 Rev. A / January 2015 17
In this section:
This section provides information and procedures for inspecting, installing, and testing the
power supply.
BASIC SETUP PROCEDURE
Below is a summary of the basic setup procedure with references to the relevant sections in
this section. Refer to this table if you are unfamiliar with the installation requirements for the
power supply. Complete each step in the sequence give
n.
Step Description Action Reference
1 Inspect Inspect the power supply. “Step 1: Inspecting and
Cleaning” on page 18.
2 Install Install the power supply
(benchtop or rack mount).
Ensure adequate
ventilation.
“Step 2: Location and Mounting”
on page 19.
3 Connect Input
Power
Connect AC input power. “Step 3: Connecting AC
Input Power” on page 20.
4 Select Wires Select wires that are
correctly rated for the
maximum DC output
current.
“Step 4: Selecting Load Wires”
on page 21.
5 Test Perform functional tests for
voltage mode operation,
current mode operation, and
front panel controls.
“Step 5: Performing
Functional Tests” on page
23.
6 Connect Loads Connect the load wires to
the DC output.
“Step 6: Connecting Loads”
on page 25.
7 Connect
Remote
Sensing (if
required)
Connect remote sensing
connectors on power supply
to load.
“Step 7: Connecting
Remote Sensing” on page
28.
Section 2
Installation