Analyze Waveform Data
Taking Manual Measurements with Cursors
Cursors are on-screen markers that you position in the waveform display to take manual measurements on acquired data. They
appear as horizontal and/or as vertical lines. To use cursors:
1.
Push
Cursors
.
This changes the cursor state. The three
states are:
No cursors appear on the screen.
Two vertical waveform cursors appear.
They are attached to the selected
waveform.
Four screen cursors appear. Two are
vertical and two are horizontal. They
are no longer speci
fi
cally attached to a
waveform.
For example, the
fi
rst time you push
Cursors
, the state might be off.
DPO3000 Series Oscilloscopes User Manual
171
Содержание DPO3000 Series
