Tektronix AWG5UP 11, Инструкция по эксплуатации

Страница: 18 / 20

Installation Instructions
8
AWG5UP 11 Instructions Manual
b. Remove the screw on the left side of the bracket.
c. Grasp the bracket and slide it out.
d. Using a screwdriver with a size Phillips #2 tip, remove the three screws
securing the hard disk to the bracket.
3. Reinstall the Flash Disk board without internal hard disk drive in the CPU Unit.
4. Reinstall the CPU Unit.
Exchange the flat cable You need to exchange the flat cable connecting the CPU board, the flash disk and
the hard disk drive.
1. Connect the flat cable included in this kit from the CPU board to the flash disk.
Install the Hard Disk Drive
1. To remove the removable hard disk cartridge, press the eject knobs by pushing
the release button to the outside, then pull out the cartridge.
2. With four M3x12 screws, washers, spacers and dampers included in this kit,
attach the hard disk drive removed from inside of the AWG520 on the A510
board. (Recommended bolting torque is 0.6 Nm)
3. Connect the flat cable from the connector on the A510 board to the hard disk
drive.
Install the new cabinet
1. Remove the four screws to remove the top cover of the Removable Hard Disk
cabinet.
2. To install the new cabinet included in this kit, do the cabinet removal procedure
in reverse order.
3. While reinstalling a cabinet, pull out the flat cable which have connected to the
CPU unit and the Flash Disk from the hole of the cabinet..
NOTE. One end of the connector near an intermediate connector is connected to the
CPU board. An intermediate connector is connected the Flash Disk. The rest of
connector will be connected to the Hard Disk Drive after the cabinet is installed.
NOTE.
When
your instrument is rackmounted AWG520:
„
Remove the handle, the handle caps, the flip stand and the feet from the new
cabinet. Refer to the AWG510 & AWG520 Arbitrary Waveform Generator
Service Manual for details.