Tektronix 013-0278-XX, Инструкция по эксплуатации

Страница: 31 / 32

013-0278-00 Video Display Clamp
21
Maintenance
This subsection provides you with the service information for the Video Display
Clamp.
Service Information
There are no user serviceable parts inside the case of the Video Display Clamp.
The TEKPROBE
TM
interface contact pins are the only replaceable part of the
Video Display Clamp.
If the contact pins become damaged, obtain replacement pins through your
nearest Tektronix Field Office or representative. Use the following procedure to
replace a damaged contact pin.
1. Using a pair of needle-nosed pliers, grasp the damaged pin and pull the pin
straight out of the assembly (see Figure 18). Note the location of the
removed pin.
2.
Using the needle-nosed pliers, grasp the replacement pin and carefully insert
the pin into the assembly. Use care to avoid crushing or bending the new pin
during installation.
3. Verify that the new pin is installed to the same depth as the other pins.
Remove Pin
with Pliers
Figure 18: Replacing the contact pins
Replacing the Contact
Pins