Tekram Technology P5T30-B4, Руководство пользователя

Страница: 31 / 42

MAINBOARD BIOS SETUP MAINBOARD BIOS SETUP
P5T30-B4 User’s Manual
29
V/H
SYNC+Blank This selection will cause the system to turn off the vertical and
horizontal synchronization ports, writing blanks to the video buffer.
Blank Screen This option only writes blanks to the video buffer.
DPMS Initial display power management signaling.
Video Off After - This is to determine when to activate the video off function. Options are:
“Standby”, “Doze” (default), “Suspend” and “N/A”.
PM Timers - The following four modes are Green PC power saving functions which are
only user configurable when User Defined Power Management has been selected. See
above for available selections.
Doze Mode
When enabled and after the set time of system inactivity, the CPU
clock will run at slower speed while all other devices still operate at
full speed.
Standby Mode When enabled and after the set time of system inactivity, the fixed disk
drive and the video will be shut off while all other devices still operate
at full speed.
Suspend Mode When enabled and after the set time of system inactivity, all devices
except the CPU will be shut off.
HDD Power
Down
When enabled and after the set time of system inactivity, the hard disk
drive will be powered down while all other devices remain active.
Throttle Duty Cycle - This item determines the duty cycle for the clock control thermal
throttling mode. The duty cycle indicates the percentage of time the STPCLK# signal is
asserted..
VGA Active Monitor - When enabled, the video detect logic will generate a timer reload
event for device monitor 11.
Resume by Ring - This item enables the modem to bring the system out of Power Saving
mode.
** Break Event From Suspend ** - When IRQ 8 Clock Event is enabled, the unmasked
IRQ8 will generate a Fast Burst Timer reload or stop break event.
** Reload Global Timer Events **
IRQ[3-7, 9-15], NMI: Enable an unmasked IRQ [3-7, 9-15], NMI, when asserted, reload the
Global Standby Timer.
Primary/Secondary IDE 0/1, Floppy Disk, Serial Port, Parallel Port: Enable reload events
from the respective device monitor to reload the Global Standby Timer.