Customizing the Board
6-9
Each register is bit read and write accessible, however, some are reserved for internal
requirements. They are described as follows:
Register #1
Bit Default
Function
WRITE Operation:
READ Operation:
0
0
Enable Watchdog
1=Enable / 0= Disable*
Same
1
1
Watchdog pulse
write 1-0 alternately to refresh
Same
2
0
Flash programming
1= Enable / 0= Disable (+12V)
Same
3
0
RS-485 direction
1= Read only / 0= Write only
Power Detect. or Batt. Low output
4
0
Reserved
W4 (7-8) Status (Ethernet)
5
0
Reserved
W4 (5-6) Status (TEKNOR BIOS)
6
1
Reserved
W4 (3-4) Status (VT100 mode)
7
0
Reserved
W4 (1-2) Status (Serial download)
Register #2
Bit Default
WRITE Operation:
READ Operation:
0
0/1
Reserved * R/W
Reserved
1
0/1
Reserved * R/W
Reserved
2
1
Data output for serial number device
Same
3
1
Enable Ethernet (1=Enable ; 0=Disable)
Ethernet Status
4
0
Reserved
Not Used
5
0
Reserved
I/O base address W3 (1-2)
6
0/1
Reserved
I/O base address W3 (3-4)
7
0
Reserved* R/W
Emergency jumper (W5) status
* Read and mask before changing bits
CAUTIONS:
1.
Not all bits are R/W. Therefore, be certain to keep a mirror image of
the register when programming it.
2.
All bits are 0 after a hardware RESET or power up condition.
As the supervisor I/O registers provide features associated to the TEKNOR Extension, the
TEKNOR Extension mode must be enabled by setting the W4 jumper that controls the
extended BIOS modes of the board (refer to Section 10 - Setting Jumpers).
Содержание TEK-CPCI-1000
