Teknobil Thuraya Vehicle Docking Adaptor, Руководство по установке и инструкция пользователя

Страница: 7 / 17

11 10
Installing the Control Box
The Control Box can be placed under the seat or any safe place. Using the mounting legs
fasten the control box tightly to the vehicle’s interior as shown in Figure 5.
FIGURE 4 Installing the VDA Holder
FIGURE 5 Installing the Control Box
Follow the exact sequence below for your safety and to avoid any damage to your unit:
• Turn off the ignition and disconnect the vehicle battery.
• Connect the leads to the Control Box and ensure that the Red lead is connected the last.
• After you connect one end of each lead to the Control Box, refer to Figure 6 and proceed
with the following connections:
° Black lead to a clean, unpainted metallic part of your vehicle for proper grounding.
° White lead to the mute input of your car audio system, if applicable.
° Red lead to the positive terminal of your vehicle's battery.
° Microphone and the Speaker to the Control Box.
° Holder cable to the Control Box.
° Privacy Handset to the Control Box.
° Car interface cable to the Control Box.
The above instructions describe how to power your Control Box from your vehicle's battery.
In this case, your unit will operate, charge your Thuraya phone and thus consume power
regardless of whether your car is running or not. Alternatively, you may prefer to power your
Control Box from the ignition switch. In this case, your unit will operate, charge your Thuraya
phone and consume power only when the ignition is ON.
Warning Your unit runs on a negative ground 12V electrical system. Connecting
your unit to a power supply with different voltage or polarity can damage your equipment.
Most trucks have 24V DC supplies. In such case, you must seek professional help
to obtain 12 V DC power supply for your VDA.
Warning Make sure the supplied fuse is properly installed. Otherwise, you may
risk fire in the unlikely event of short circuit in the system.