Tekno RC EB48.3, Инструкция по сборке

Страница: 6 / 28

TKR5075
TKR5016B
TKR5152
TKR5016B
TKR5269
TKR1222
TKR1222
TKR1525
TKR1529
TKR1222
TKR1529
TKR5181
TKR1525
TKR1222
TKR1525
TKR1226
TKRBB05134
TKR1525
M3x14mm Cap Head Screw
x4
TKR1603
M5x4mm Set Screw
x1
TKR1222
13x16x0.1mm Diff Shim
x2
TKR1226
5x7x0.2mm Shim
x1
TKR1603
TKRBB05134
TKRBB05134
TKR1226
TKRBB05134
TKR1603
TKR1525 TKR1525
Grease
Front
Rear
Note: flat spot
Note: flat spot
Note: The front and rear
bulkheads are different.
The front has a much
greater output angle
compared to the rear.
*may not be needed
*may not be needed
TKR1529
M3x20mm Cap Head Screw
x1
Bag D
Rear Gearbox
(overview)
6
Thread
Lock
Step
D-1
Step
D-2
Step
D-3
Note: TKR1222 and TKR1226 Shims - The gear mesh should be tight without any binding. TKR1226 should
always be installed. Then test fitment of the diff with both TKR1222 shims on the gear-side of the diff. If the diff
turns freely without binding, continue to next step. If the diff binds and does not turn freely (it will make a
grinding or crunching sound when spun), remove one TKR1222 shim from the gear side and install it onto the
other side of the diff. Reassemble and test the mesh again. If it is still binding, remove the second TKR1222 shim
from the gear side and install it onto the other side of the diff. When you are satisfied that you have the best
gear mesh possible continue to the next step. You may end up using only one shim on the gear side.
TKRBB05134
Ball Bearing (5x13x4)
x2