5
•
Avoid positioning the appliance near cookers, radiators or in direct sunlight, as this will cause the compressor to run
for long periods. If installed next to a source of heat or refrigerator, maintain the following minimum side clearances:
From Cookers
4" (100 mm)
From Radiators
12" (300 mm)
From Fridges
4" (100 mm)
Make sure that sufficient room is provided around the appliance to ensure free air circulation. Ideally, A space of no less
than 10cm must be left around the freezer, and ensure you allow gaps as shown in the below diagram.
•
The appliance should be located on a level surface.
•
It is advised not to use the refrigerator outdoors.
•
Protect from moisture. Do not locate the freezer in a moist area to avoid the metal parts becoming rusty, do not
spray water to the freezer; otherwise it will weaken the insulation and causes current leakage.
•
Refer to "Cleaning and Care" section to prepare your appliance for use.
If the freezer is installed in unheated areas, garages etc in cold weather condensation may form on the outer surfaces.
This is quite normal and is not a fault. Remove the condensation by wiping with a dry cloth.
STARTING
Before using the freezer, please read below:
•
Make sure that the interior is dry and keep air circulating at the back of cabinet.
•
For the details concerning the method of cleaning, please see section "CLEANING AND CARE"
•
After Inserting the plug into the socket, the LED lights and digital display will illuminate for a while and will return to
normal after 2 seconds; In setting mode, if no button is pressed within 5 seconds, all buttons will be locked automatically.
•
Temperature can be set between - 24
℃
~ - 16
℃
. The default temperature setting is -18
℃
.
•
You may hear some noise as the compressor starts running. The liquid and gas in refrigeration system may also
make noise, no matter the compressor is running or not. This is a normal phenomenon.
•
Before storing the food which are already frozen, please open the freezer door and check if the freezer has reached
the correct temperature. Then put into the frozen food.
•
Do not load the appliance immediately just after it is switched on. Wait until the correct storage temperature has
reached. We recommend that you check the temperature with an accurate thermometer.
•
Due to individual factors of the refrigerator, the actual temperature in the box may have a certain error
from the set temperature, which is a normal phenomenon and does not affect the normal use of the
product.
Important Notes:
•
If there is a power failure, do not open the door. Frozen food should not be affected if
the power failure lasts for less than 38 hours. If the failure is longer, then the food should be
checked and eaten immediately or cooked and then refrozen.
•
If you find that the door of the chest freezer is difficult to open just after you have
closed it. Don
’
t worry about it. This is due to the differential pressure, which will be
equalized and allow the door to be opened normally after a few minutes.
FREEZER OPERATION
Unlock Settings
Under the lock state, press both the
“
Up
”
and
“
Down
”
buttons at the same time for 1s, then
operation buttons get unlocked. And Parameter setting is enabled, with the current
temperature setting flickering.
•
Press "Up" key once, the temperature increases by 1
℃
; Press "Down" key once, the
temperature decreases by 1
℃
; If no button operation within 5 seconds after each setting,
the current set temperature shows on display will be fixed by the system automatically.
Then the display will stop flickering.
Super-Freezing function
•
Press the "Super FRZ. " button, the temperature is set to - 30
℃
automatically, digital flickers
”
- 30
℃
”
.
And meantime
the indicator light of
"Super FRZ. "
is on,
The flickering
will stop in 5 seconds, then
Super-Freezing function starts.
•
After running 26 h, Super-Freezing function will stop automatically. The
indicator
goes out. It reverts to previous state.
•
Under button unlock state during Super-Freezing mode, press the"Super FRZ. " button, Super-Freezing function will
stop. The
indicator
goes out. It reverts to previous state.
Temperature alarm function
l
The sensor temperature will be detected after the freezer is energized for 3 hours. If the sensor temperature is higher
