118-1214-010 12
OPERATION INSTRUCTIONS:
Ensure the “ON/OFF” switch is in the “OFF” position before plugging the power cord into
the AC power source. Ensure there are no tools or work pieces in contact with the chosen
VERSA TURN Accessory when the NOVA Comet II Midi Lathe is turned “ON.” Failure to
observe these procedures could result in damage to the chosen VERSATURN™ Accessory,
tools, work pieces, or serious personal injury to the operator or bystanders. Limit speed to
maximum recommended rpm per the chosen VERSATURN™ Accessory manual and always
start machine at zero (0)
Always allow the chosen VERSATURN™ Accessory to run for at least one minute to
warm up.
1.
Carefully choose a location for the NOVA™ Comet II Midi Lathe and VERSATURN™
Coupler Accessory. If mounted on a workbench, ensure there is adequate room all
around the accessory for safe operation. The area must be level and clear of other power
tools and/or power tool cords that could interfere with operation of the VERSATURN™
Accessories.
2.
The VERSATURN™ Accessories should be installed on the NOVA™ Comet II Midi Lathe
in a place that is away from outside elements.
3.
Rotate the VERSATURN™ Coupler Lock Ring anticlockwise until the "Unlocked" Tab (5)
is on top. Align the outboard end of the Comet II Lathe spindle (1) with that of the chosen
VERSATURN™ Accessory shaft (2). (Figure 4 and 5)
4.
Press the chosen VERSATURN™ Accessory (3) up against the rubber mounting surface
inside the VERSATURN™ Coupler on the lathe (4). (Figure 4 and 5)
Figure 4
Figure 5
