118-1214-010 11
3. Place the Coupler Interface (2) and
Coupler Lock Ring (1) over the Comet II
Spindle (B) and up against Coupler
mounting face on the Comet II (A).
4. Align the mounting holes on the Coupler
Interface (2) with the threaded holes on the
Coupler Mounting face (A).
5. Insert a Screw (4) with spring lock washer
(3) into each mounting hole and tighten.
6. Place the Rubber Gasket (5) on the
Coupler interface (2), with the flats of the
Rubber Gasket facing the stop tabs of the
coupler interface (2).
Figure 3
