Teka EWH 50 D SLIM, Инструкция по эксплуатации

Страница: 38 / 45

1
.
2
.
3
.
4
.
The supply socket must be earthed reliably. The rated current of the socket
shall not be lower than 10A. The socket and plug shall be kept dry to
prevent electric leakage. Inspect frequently whether the plugs are well
plugged in the socket. Inspect method is as follows: insert the power
supply plug into the socket,after using for half an hour, shut down the unit
and pull the plug out, and inspect the plug in case it scalds your hand. If
tempeature is over 50
℃
, please plug in another socket. to avoid the plug
being damaged, fire or other personnel accidents result from badcontact.
For the places or the wall where the water may splash, the installation
height of the socket shall not be lower than 1.8m.
The wall in which the electric water heater is installed shall be able to bear
the weight equalling twice the weight of the heater fully filled with water
without distortion or cracks. Otherwise, other strengthening measures
The one-way safety valve attached to the machine must be installed to the
cold water inlet of this machine (see Fig.6).
should be adopted.
For the first use (or the first use after maintenance or cleaning), the heater
can not be switched on until it has been (fully) filled with water. When filling
with water, at least one of the outlet valves at the outlet of the heater must
be opened to release the air. This valve can be closed after the heater has
been (fully) filled with water.
During the heating, there may be drops of water dripping from the pressure
release hole of the one-way safety valve. This is a normal phenomenon. If
there is a large amount of water leaking, please contact the professional
maintenance personnel for repair. This pressure release hole shall, under
no circumstances, be blocked; otherwise, the heater may be damaged,
even resulting in safety accidents.
5.
6.
7
⑤ From "5"&"6" , customer could know heating status . The light "5" will turn
on when power is connected. The light “6“ will flash when smart control
energy saving mode is started. According the temperature setted, the
light “5" will be shown in red which means water heater is being heated.
When inner water heater temperature reaches the setted value , light “5"
will be shown in white, which means water heater enter into warm-keeping
status.
⑥
"4" could show the current inner water temperature as well as setted
temperature value.If no person operates on water heater , the value in
display screen " 4" means current temperature value .By spinning knob
"3" , "4" values will vary accordingly ( i.e temperature setting process) ,
when finish temperature setting , "4" values will return back to actual current
inner water heater temperatrue