Teka DF-90, Инструкция по эксплуатации

Страница: 12 / 31

12
EN
G
TEKA INDUSTRIAL S.A. reserves the right to make changes and corrections to its products as
it deems necessary, without altering their basic characteristics .
The intensive speed "H" can only be selected
manually and will change to speed 2 after
approximately 10 minutes.
Clean the filters when the saturation indicator lights
up. (See page 12, Filter cleaning section).
Once you have cleaned the filters, and with the
hood turned off, press the increase and decrease
speed buttons at the same time for 3 seconds and
the indicator will switch itself off.
During cleaning and maintenance work, make
sure the safety instructions set out on page 10
are complied with.
• If your kitchen hood is made from stainless steel,
use proprietary cleaners mentioned in the
product instructions.
• Never use metallic scourers, nor abrasive or
corrosive products.
• Dry the kitchen hood using a cloth that does not
produce fibres.
To remove the filters from their fittings, press lightly
on the locks and then pull them off.
The metal filters can be cleaned by soaking them in
hot water with neutral detergent until the fat
dissolves and then rinsing them under the tap or
using special anti-grease products. They can also
be washed in a dishwasher. In this case, it is
advisable to stack them vertically to avoid food
residues to stick to them.
Cleaning in a dishwasher may damage the metallic
surface (blackening it), although this will not affect
its fat retention capacity.
Once clean, leave them to dry off and then fit them
onto the kitchen hood.
Proceed as follows:
• Unscrew the lamp cap trimming cover.
• Change the broken/ burnt out lamp. Maximum
lamp power is 20 W (G-4).
• Screw in the lamp cap trimming cover.
Cleaning the metal filters
Cleaning the hood body
Cleaning and maintenance
_________________________________________________________
Problem solving
Proceed with the following checks before calling the Technical Service:
Changing light bulbs
Sizes and specifications
See page 30.
Filter saturation indicators “F”