BA_Airfilter Mini_151210_GB.doc
- 8 -
22.07.2013
4.2 Function description
The Airfilter is used for extracting gases and fumes contaminated with harmful substances.
Either using a suction arm (accessory) extracted directly from the environment of the Airfilter
or a suction hose is directly closed between the machine to be extracted and the Airfilter.
The Airfilter is either switched on or controlled on the membrane keyboard or by the control of
the machine to be extracted (remote switch automatic mechanism).
The gases/fumes extracted by the suction hose/suction arm are extracted into the filter hous-
ing with the used combifilter.
The combifilter consists of the following three filter levels:
–
Pre-filter mat,
–
Air filter and
–
Activated carbon filter with filter end stage.
The clean gas is extracted by turbine below the activated charcoal filter and then emitted to
the atmosphere through the sound absorption module attached at the side.
The Airfilter is connected to the mains supply using a appliance inlet (included). The appli-
ance inlet for the power supply of the Airfilter is positioned on the turbine housing near the
sound absorption module.
4.3 Connection to the external control
A control cable with a sub D9 connection is required for operating the Airfilter via a remote
switch automatic mechanism. The pin terminal assignment of the sub-D9 connection (see in
section 4.5.2) is to be complied with!
4.4 Technical data
Manufacturer:
TEKA GmbH
Industriestrasse 13
D - 46342 Velen
Tel.:
++49 (0) 28 63-92 82-0
Fax:
++49 (0) 28 63-92 82-72
e-Mail: service@ teka.eu
Product designations:
Airfilter MINI
Housing MINI:
Width
365 mm
Height
626 mm
Depth
376 mm
Housing material
Sheet steel, lacquered
