Teka AFC 87628 MST BK, Инструкции по установке и рекомендации по использованию и обслуживанию

Страница: 49 / 164

EN
49
the symbol (24). This mode does
not function if the Fresh function is
activated.
Fresh function
By activating this function the extractor
system stays on at level 1 for 10
minutes and then switches off for
50 minutes. This cycle repeats for
24 hours.
Four flashing segments will be
displayed and will scroll around the
edge of the power digit
.
It is activated by pressing the symbol
(25) whilst to deactivate it, press
the activation key once more or press
the symbol
.
Cleaning the extractor
module
Warning: Before starting any cleaning
or maintenance operation, make sure
that the cooking areas are completely
cold and that the power supply to the
appliance has been cut by turning the
hob’s power switch off , for example.
Cleaning the metal grease fi lters
After 30 hours of hood operation, with
the hood switched off , the value F1 will
fl ash on the power display.
The fi lters can be cleaned by hand
with a degreasing detergent or they
can be cleaned in a dishwasher at
a maximum temperature of 50°C.
Washing in the dishwasher may
discolour the fi lter but its effi
ciency will
not be aff ected.
After having cleaned the filter, the
indicator can be reset by pressing and
holding any part of the pointer
for more than 3 seconds.
Cleaning the anti-odour fi lter
The anti-odour filter is optional
and is sold separately. Activate the
operation time control by following the
instructions in the chapter,
Operating
modes.
After 125 hours of hood operation, with
the hood switched off , the value F2 will
fl ash on the power display.
Filter cleaning should be performed
according to the type of filter
purchased.
Ceramic fi lter
The filter can be regenerated by
placing it in a preheated oven at 200°C
for 45 minutes. Regeneration allows a
maximum fi lter life of 5 years.
Long-life fi lter
After 125 hours of operation, the
regenerable activated carbon
filters (long-life) can be washed
in the dishwasher at a maximum
temperature of 65 °C (complete
washing cycle without dishes) or
by hand with neutral non-abrasive
detergents. Remove any excess water
without damaging the fi lter and place it
in the oven for 10 minutes at 100 °C to
dry it off completely. Replace the mat
every 3 years or whenever the cloth
is damaged.
After having cleaned the fi lter, the
indicator can be reset by pressing and
holding any part of the pointer
for more than 3 seconds.