LED BOARD / OPTICS
L10-L18
Warning
Hot Surface
1. Remove lower assembly of fixture to access
LED board. Loosen set screws with 7/64” Allen
wrench.
3. Loosen LED board from heatsink by using 5/64”
Allen wrench on three (3) #2-56 screws on LED
board.
7. Connect wiring to new LED board by placing
into wire connectors. Wire will ‘push’ into place
inside holder. Black wire inserts on AC Line,
while white wire inserts on Neutral.
2. Gently press on tabs of LED wire holders to
allow wiring to be removed from LED board.
5. Spread new thermal paste in even layer on
heatsink. Feed wiring from quick connect
through new board.
Line up new LED board and place on heatsink.
IMPORTANT - WEAR GLOVES TO AVOID GETTING FINGERPRINTS ON THIS PRODUCT. MANY TEKA ILLUMINATION PRODUCTS ARE DESIGNED TO NATURALLY
PATINA. OILS FROM YOUR SKIN WILL ACCELERATE THIS PROCESS WHERE TOUCHED AND ARE NEARLY IMPOSSIBLE TO REMOVE. THIS PROCESS OCCURS
OVER TIME AND IS DETERMINED BY THE INSTALLATION ENVIRONMENT.
Wear Gloves
High Voltage
8. Reverse install fixture body assembly by
tightening set screws with 7/64” Allen wrench.
IMPORTANT SAFETY
INFORMATION
• Product must be installed by a qualified
person in a manner consistent with its
intended use and in compliance with
the National Electrical Code, Canadian
Electrical Code, and all Local and Provincial
Codes.
• Follow product label information and
instructions.
• Qualified Personnel must perform all
servicing or relamping of this product.
•
Before wiring to power supply and
during servicing or relamping, turn off
power at fuse or circuit breaker before
service.
TOOLS
NEEDED:
By Others
7/64” & 5/64” Allen Wrench
Thermal Paste (Supplied)
Gloves
Replacement
IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
DATE
7-18-18
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.tekaillumination.com • [email protected]
REFERENCE NUMBER
INS-2614-00
4. Remove old board by carefully pulling away.
6. Secure new LED board to heatsink with three
(3) #2-56 screws using 5/64” Allen wrench.
