TeHa BR1000 ECO PLUS, Руководство пользователя

Страница: 5 / 31

5
5.2.4 Adjustment of the regulating devices , 5.2, Pos. 1–3, leads to the following changes:
1) more air: better smoke appearance
lower CO2 – value
higher exhaust gas temperature
worse ignition behaviour
2) pulling out of the nozzle tube: better smoke appearance
lower CO2 – value
better ignition behaviour
3) higher oil pressure: worse smoke appearance
higher CO2 – value
higher exhaust gas temperature
worse ignition behaviour
better heating capacity
By changing the values a compromise has to be found which produce the best possible performance.
Inspection of the burner chamber
Remove the mixing device as described under item 5.1.
Remove outer lid (P. 7, Pos. 6) Pull out the inner lid (P. 7, Pos. 7) with flame tube, inner tube and chimney and remove
possible soot accumulation. Now the inner part of the heating coil can be reached and examined by means of an exterior
source of light (a torch e.g.).
Small layers of soot and corrosion can be loosened by using a scratch brush and removed by using a vacuum cleaner.
(Attention: Avoid damaging the insulating plate (S. 7, P. 34)
Spray the entire heating coil with soot spray as completely as possible before re-assemblance. After correct adjustment
of the burner the soot will burn out, however be prepared for some excessive smoke while the burner clears this soot.
Defective heating coil (entirely sooted, entirely calcified, damaged by frost, excessive pressure or faulty material)
The replacement of the heating coil requires the removal of the entire combustion chamber.
Having removed the combustion chamber the procedure is as follows:
Remove the mixing device as described under item 5.1.
Remove the outer and the inner lid as described under item 5.3.
Turn the combustion chamber from its vertical axis for 180° and place it with its heating coil on a cylinder
with diameter Ø 270mm x height 200 mm ( approx. measurements).
Remove 2 brass nuts (P. 7, Pos. 25) Pull off the outer casing upward (P. 7, Pos. 35) Remove 2 spacer tubes (P. 7, Pos. 33)
Pull off the inner casing upward (P. 7, Pos. 36) Remove remainder of the insulating plate (P. 7, Pos. 34)
Place the new heating coil onto the assistant cylinder. Re-assemble in reverse order.
A new insulating plate absolutely has to be used and make sure that the spacer tubes are not forgotten
(P. 7, Pos. 33) + (P. 7, Pos. 38)
Fuel Filter
- The filter cartridge should be exchanged at least every year or more often depending on use and quality of fuel.
- Every year the cover of the housing has to be removed and the pump has to be cleaned with either cleaning petrol
or compressed air.
- The fuel tubing has to be checked for leaks.
6. Safety Notice
Service and repairs should only be carried out by trained professionals.