9
10
INSTALLATION INSTRUCTION
Always be sure that the tool is switched off and the battery cartridge is removed
before carrying out any work on the tool.
WARNING
Installing abrasive disc
To install the abrasive disc, first remove all dirt or foreign matter from the pad. Then attach the
abrasive disc to the pad. Be careful to align the holes in the abrasive disc with those in the pad.
Installing dust bag (optional accessory)
Install the dust bag on the tool with its mouth directing downwards.
Emptying dust bag
When the dust bag is about half full, switch off the tool, and remove the dust bag from the tool.
Then remove the dust nozzle from the dust bag after unlocking the dust nozzle by turning it
slightly counterclockwise. Empty the dust bag by tapping it lightly.
After emptying the dust bag, install the dust nozzle on the dust bag. Turn the dust nozzle slightly
clockwise to lock it in place. Then install the dust bag on the tool as described in "Installing dust
bag".
Installing paper filter bag (Optional accessory)
Make sure that the logo on the cardboard lip and the logo on the dust box are on the same side,
then install the paper filter bag by fitting the cardboard lip in the groove of each holding tab.
Make sure that the logo on the cardboard lip and the logo on the dust nozzle are on the same
side, then install the dust nozzle on the dust box.
Removing dust box and paper filter bag
Remove the dust nozzle by pushing the two latches.
Remove the paper filter bag first by pinching the logo side of its cardboard lip, then by pulling the
cardboard lip downwards to move it out of the holding tab of the dust box.
Do not use the tool without the skirt. Otherwise dust is scattered all over.
WARNING
You can choose one of 12 directions of the skirt in accordance with your purpose.
To remove the skirt, remove the screw and remove the skirt with slightly opening it for both sides.
To reinstall the skirt, install it with slightly opening it for both sides. And fasten the screw.
Removing and reinstalling the skirt
Do not set the skirt other than the designated angle.
Otherwise the tool may be
damaged.
WARNING
