9
10
10. Make sure the blade is not contacting the workpiece before the switch is turned on.
11. Wait until the blade attains full speed before cutting.
12. Always switch off and wait for the blades to come to a complete stop before any adjusting.
13. Never stick your finger into the chip chute. Chute may jam when cutting damp wood. Clean
out chips with a stick.
14. Do not leave the tool running. Operate the tool only when hand-held.
15. Always change both blades or covers on the drum, otherwise the resulting imbalance will
cause vibration and shorten tool life.
16. Use only blades specified in this manual.
17. Always use the correct dust mask/respirator for the material and application you are working
with.
Always be sure that the tool is switched off and the battery cartridge is removed
before adjusting or checking function on the tool.
WARNING
INSTALLATION INSTRUCTION
Always be sure that the tool is switched off and the
battery cartridge is removed
before carrying out
any work on the tool.
WARNING
REMOVING OR INSTALLING PLANER BLADES
1
.
Tighten the blade installation bolts carefully when attaching the blades to the tool.
A loose installation bolt can be dangerous. Always check to see they are tightened
securely.
2. Handle the blades very carefully. Use gloves or rags to protect your fingers or
hands when removing or installing the blades.
3. Use only the wrench provided to remove or install the blades. Failure to do so
may result in over tightening or insufficient tightening of the installation bolts. This
could cause an injury.
WARNING
FOR TOOL WITH CONVENTIONAL PLANER BLADES
1. Socket wrench
2. Bolt
3. Loosen
4. Tighten
1. Bolts
2. Drum
3. Planer blade
4. Drum cover
5. Adjusting plate
1. Inside edge of gauge plate
2. Blade edge 3. Planer blade
4. Adjusting plate 5. Screws
6. Heel
7. Back side of
gauge base
8. Gauge plate 9. Gauge base
2
1
3
4
2
1
3
4
5
1
2
3
4
5
6
7
8
9
