19
20
MAINTENANCE
Always be sure that the tool is switched off and the
battery cartridge is removed
before attempting to
perform inspection or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
like. Discoloration, deformation
or cracks may
result.
WARNING
Immerse the dressing stone in water for 2 or 3 minutes
before sharpening. Hold the holder so that the both blades
contact the dressing stone for simultaneous sharpening at
the same angle.
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep the
carbon brushes clean and free to slip in the holders.
Both
carbon brushes should be replaced at the same
time. Use
only identical carbon brushes
REPLACING CARBON BRUSHES
Use a screwdriver to remove the brush holder Take out the
worm carbon brushes, insert the new ones and secure the
brush holder caps.
To maintain product SAFETY and RELIABILITY, repairs any
other maintenance or adjustment should be formed by
TEH Authorized Service Centers, always using TEH
replacement parts.
Always keep your blades sharp for the best performance
possible. Use the sharpening holder (optional accessory) to
remove nicks and produce a fine edge.
For conventional blades only
SHARPENING THE PLANER BLADES
1. Sharpening holder
1
First, loosen the two wing nuts on the holder
and insert
the blades (A) and (B), so that they
contact the sides (C)
and (D). Then tighten the
wing nuts.
1. Wing nut
2. Blade (A)
3. Blade (B)
4. Side (D)
5. Side (C)
1
2
3
4
5
1. Limit mark
1
1. Brush holdercap 2. Screwdriver
1
2
